China Fully Automatic Mesh Welding Machine for Construction Fence is also known as the coal mine protection mesh welding machine. The mesh produced by China Fully Automatic Mesh Welding Machine has high tensile strength, the net surface is flat, the solidity is not easy to pull open, and the safety factor has reached the national standard. The mesh produced by China Fully Automatic Mesh Welding Machine is mainly used in artificial false roof of coal mines, which can reduce the cost of coal and save lead wire. China Fully Automatic Mesh Welding Machine has become a new technology promoted in China's coal industry, and has been promoted and used in protection dams, fence breeding, etc., and now it has become a construction industry.
A new type of material that has the effect of reinforcing steel. This kind of net produced by the Fully Automatic Mesh Welding Machine can be new and practical. And will be promoted and used. This is a good way for professional investment and entrepreneurship. Coal mine weft and reticular network process: in the original material selection smelting, casting, extrusion, stretching, annealing, pickling, joint drawing, fine grinding, warp knitting and other processes. Material: galvanized iron wire, low carbon steel mesh: 2 cm - 10 cm Wire diameter: 2 mm - 4 mm Net width: 1 m - 1.2 m Length: 10 m / volume Note: Special specifications can be customized according to customer needs!
China Fully Automatic Mesh Welding Machine for Construction Fence compacting device is composed of a rotating shaft, a sleeve and a pressing ring. The rotating shaft has a groove, the sleeve and the pressing ring are sleeved on the rotating shaft, and the sleeve is fixed on the base, and one end of the rotating shaft is pressed by a handle. . The pressing ring is an eccentric ring having a hole therein, and the screw extends through the hole into the groove of the rotating shaft, and the number of the wire determines the number of the pressing ring. A certain weft device is installed in the net pulling device, and the weft adjusting device is installed under the hook, which is composed of a rotating shaft, a pressure spring and a bushing. The pressure spring and the bushing are sleeved on the rotating shaft, and the screw is pressed on the bushing, and the pressure spring is tight. The sleeve is clamped at one end to the screw on the sleeve, and the other end is extended upward. The fixed weft ruler is fixed on the base of the weft-fixing device in front of the rotating shaft, and the base is fixed on the welding net of the construction net.